Shimming O Scale Couplers
I managed to get a little bit more work done on this hopper conversion project today. (As mentioned in previous blog entries, I'm converting four American Flyer S scale hoppers to O scale narrow gauge hoppers.)
Last weekend, I had previously cut two different sizes of bulkhead shims for shimming the coupler boxes to the correct height from the rail but I had not glued them in place. That was today's job.
Since I had already pre-cut all the shims, today's work was fairly easy. I had a little bit of trimming to do on the first of eight sets of shims but I today's task was to simply glue each shim in place with some super-glue gel.
Next, I can glue some brake wheels in place on one end of each hopper. Hopefully that will be quick and easy task too. Hmmm... I need to pick up more glue first...
I just remembered that I also need to build or buy some stirrup steps for each of the four hoppers. Once these are installed then I can spray paint each of the cars...
Little by little, this project is coming along.
Last weekend, I had previously cut two different sizes of bulkhead shims for shimming the coupler boxes to the correct height from the rail but I had not glued them in place. That was today's job.
Since I had already pre-cut all the shims, today's work was fairly easy. I had a little bit of trimming to do on the first of eight sets of shims but I today's task was to simply glue each shim in place with some super-glue gel.
Next, I can glue some brake wheels in place on one end of each hopper. Hopefully that will be quick and easy task too. Hmmm... I need to pick up more glue first...
I just remembered that I also need to build or buy some stirrup steps for each of the four hoppers. Once these are installed then I can spray paint each of the cars...
Little by little, this project is coming along.
Comments
Post a Comment